Stovax Indoor Fireplace 8902 User Manual

INSTALLATION  
Fitting Cast front panel (8901 / 8902 / 8903)  
Safety  
As with all fireplaces the surfaces will become very hot when  
in use, therefore due care should be taken when near the  
fireplace. If it is to be used in the presence of young children,  
elderly or infirm persons a suitable fireguard should be used.  
Care should also be taken with the placement of combustible  
items near the fireplace as conducted and radiated heat could  
cause a fire hazard.  
Ensure that the floor of the fireplace opening is level with  
the projecting hearth surface. If a cement infill is required to  
achieve this, do not proceed with the installation until the  
cement is completely dry.  
Cover the surface of the hearth to protect it from damage  
during installation of the cast panel.  
Stovax offer a wide range of firescreens and sparkguards, along  
with a hearthgate system designed to offer full protection for a  
range of stoves and fireplaces. Your Stovax dealer can advise  
you on these products.  
Protect the surfaces of the surround (mantelpiece) from damage  
when trial fitting of the panel.  
Position the front panel centrally in the fireplace opening  
against the wall. Place the surround (mantelpiece) in position  
and, holding it firmly against the wall, pull the front panel  
forward until it touches the rear of the surround. The panel is  
now in the correct position and should be fixed. The surround  
can be removed while this is completed.  
If a chimney fire occurs evacuate all persons from the building  
before calling the fire brigade. Do not re-enter the building  
until it is confirmed safe to do so.  
Following a chimney fire do not use the fireplace until it is  
inspected, by a HETAS (GB only) registered installer, to confirm  
that the appliance is safe to use, or make any repairs required  
before re-use. Only genuine Stovax replacement parts are to be  
used to keep your fireplace in safe and efficient working order.  
After any chimney fire it is recommended that the chimney  
system be inspected and swept by a NACS registered (UK only)  
chimney sweep, to confirm that the system is structurally sound  
and free from any obstructions before re-use.  
There are a number of ways of fixing the front panel, but a  
typical method is:-  
Drill through the 4 corners of the main panel in a position that  
will be covered when the surround is in position. Drill holes in  
the wall in corresponding position, and secure the front panel  
with 75mm (3”) screws and non-plastic wall plugs. Fill any  
gaps between the wall and the panel with a non-combustible  
material, such as fibreglass rope seal or Stovax fire cement, to  
form airtight seal.  
MAINTENANCE  
Never use strong Portland cement mortar in chimneys and  
fireplaces. A lime based mortar will allow expansion and  
movement and reduce the risk of cracking.  
For fully polished fireplaces Stovax Steel Cleaner (Part No.  
2037) is recommended to keep them clean and rust free. If  
a fire is not to be lit for an extended period, it is advisable  
to coat with a light oil to prevent moisture in the air causing  
surface rust and pitting of the cast iron. This is important when  
plastering or other decorating work is being done.  
Wait until any cement or seals are dry before fitting a wooden  
surround. If the surround is wood, fix Stovax flat rope seal (Part  
No. 4953) to all surfaces that touch the cast iron panel. Place it  
into position ensuring that it is central, and secure it to the wall  
using flat brass brackets (mirror plates).  
Cast Iron  
London Fronts  
Models: 8901, 8902, 8903, 8904  
E & OE.  
With Solid fuel fires use only at a low fire for the first few hours  
of use to allow the castings to temper.  
During this time the fireplace may give off some unpleasant  
odours, and we recommend that you keep the room well  
ventilated to avoid a build-up of fumes.  
Installation Instructions  
This product is suitable for use in the stated countries. To install the product in other countries it is essential to obtain translated instructions  
and in some cases the product may require modification. Contact Stovax to obtain further information.  
Stovax Ltd, Falcon Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7LF  
Tel: (01392) 474011 Fax: (01392) 219932 E-mail: [email protected] www.stovax.com  
IMPORTANT  
Please read these instructions carefully before using the appliance.  
Keep them safe for future reference and when servicing the stove.  
PM190-Issue 1 (October 2006)  
 

Sennheiser Microphone MKH 8060 User Manual
Sony CRT Television KV 24FS120 User Manual
Sony Projector VPL VW50 User Manual
SoundCraft Music Mixer MPM 12 2 User Manual
Soundstream Technologies Speaker SM16 90 User Manual
Strong Pools and Spas Swimming Pool Vacuum Victory Spa User Manual
Sunbeam Refrigerator SBCR139WE User Manual
Swann Security Camera SW215 DML User Manual
Sylvania TV DVD Combo 6727DE User Manual
Symbol Technologies Telephone CDM 8910WW User Manual